Homa Installation of 1 and a Half Inch Guide Claw Wit C Manuale Utente Scaricare il pdf

Publication

88PN3010A

Please Contact

Technical Support At 203

736

8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

1 of 2

Installation of 11/4” Guide Claw

With Check Valve

• Apply thread sealant to one end of the 1 ¼” close nipple.

• Thread 1 ¼” close nipple into bottom of riser tube (check valve body). Drop check ball

into riser tube. Place large diameter rubber gasket over the top of riser tube groove.

• Place ball cover over gasket and fasten with screws, washers and nuts provided. The

nuts will be held in place and kept from spinning by the bosses cast into the riser tube.

Place a washer over the bolt and apply thread locking compound such as blue #242.

Ball Cover

Rubber Gasket (Large)

Check Ball

Riser Tube (Check Body)

Rubber Gasket (Small)

Guide Claw

1 ¼” Close Nipple

Profile Seal

1 2

Publication 88PN3010A Please Contact Technical Support At 203-736-8890 With Any Additional Questions Please Be Prepared To Provide Pump Serial Numbe

Publication 88PN3010A Please Contact Technical Support At 203-736-8890 With Any Additional Questions Please Be Prepared To Provide Pump Serial Numbe

Nessun commento

Homa Installation of 1 and a Half Inch Guide Claw Wit C Manuale Utente